Snowboard Forward Lean Block


19 September 2015

Snowboard Forward Lean Block Featured Image


Replacement forward lean block for a snowboard binding to replace a worn-out and damaged part. Based on the worn-out part taken off a pair of Union Bindings.


Print standing up on the flat end at 100% or 70% fill. The teeth will print great without any support this way. Due to the small footprint, print with a large brim.

Recommend abs for strength as this is a mechanical part that will have considerable forces imparted on it during hard heel-side turns, landings, etc. PLA seems to work fine as well, just probably won't last quite as long.

Loidolt Design © 2022