Window Blind Cord Child Proofing
Summary
Magnetic detachable window blinds cord hanger. Keeps the cord from your blinds up off the ground for child proofing, robot vacuums, or whatever other reason you want cords to be managed and up out of the way.
I designed these to replace the commercial options out there that cost upwards of $8-10 dollars per window, which is crazy for some plastic and a few magnets.
Uses cheap, ceramic round fridge magnets that can be readily found on Amazon or eBay in packs of 100 for about $8. Magnet size is 18 mm x 5 mm (though the magnets tend to be slightly smaller than their stated dimensions and the model reflects this).
Each window will need 3X 18 mm x 5 mm ceramic magnet.
Print Settings
Printer brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: No
Resolution: 0.15
Filament_brand: Any
Filament_color: Any
Filament_material: PLA
Notes: Higher resolution is better since these are small parts with threads. If the thread fit is too tight, check your extrusion settings.
Post-Printing
Assembly Instructions
Place a magnet in the back of the base part and attach to the wall using double sided mounting tape.
Place a magnet in the male half of the cord clamp (be sure it is attracted to the base magnet on the outside face).
Place the cord in the slots seen on the side of the male clamp piece.
Place another magnet in opposing magnetic orientation of the first magnet on top of the cord.
Carefully hold the top magnet in place and screw on the female half of the cord clamp until the assembly no longer slides on the cord.
Test and enjoy!